| Closing Unit | | |
| Closing Force | kN | 1600 |
End of closing force
| kN
| 32 |
| Setting-off force | kN | 62,5 |
| Opening Stroke | mm | 350 |
Clamp maxi. useful
| mm | 15 |
| Distances between platens | | |
without sliding platen
| | 790/755 |
with sliding platen
| | 750/715 |
| between guide columns | mm | 500 X 250 |
| Mold height min/max | mm |
|
| without sliding platen | | 210 / 425 |
| with sliding platen | | 170 / 385 |
| Heater plates: | |
|
| Width x length | mm | 430 x 510 |
Heating power (400 V)
| kW | 2 x 4,9 |
| Injection unit | | 2 x Y 1000 |
Lift stroke
| mm | 352
|
Beardown force: fullforce/low
| kW | 49 |
Extrusion L/D =15
| | |
| Screw Diameter | mm | 32 |
| Extruder speed | rpm | 0 - 208 |
| Average ouput | cm3/ mn | 1160 |
| Heating power (400 V) | kW | 2,3 |
Recommended rubber strip section
| mm | 35 x 6,5
|
| Injection | | |
Piston diameter
| | |
| Shot capacity | cm3 | |
| Injection pressure | bar | |
| Heating power (400 V) | kW | 3,4 |
| Hydraulic Unit | | |
| Type of pump | | 2 x variable displacement |
| Pump output in charge | 1/mn | 44 |
| Working pressure | bar | 250 |
| Motor power | kW | 15 |
| Tank capacity | l | 200 |
| Electric Unit | | |
| Total installed power (400 V) | kW | 53 |
| Total power with options | kW | 75 |
| Space requirement | | |
Width x depth on the floor
| mm | 2350 x 2800 |
Max height
| mm | 3580 |
Average weight (depends on options)
| kg | 4450 |
