- Duration: 2 days (14 hours)
- Language: French or English
- Place: 15 rue du Dauphiné F-69960 CORBAS
Quotation on request for a customized session on your site - Deadline to access to the training: allow 6 weeks before the course starts.
Details of the course
People concerned:
- Machine set-up operator
- Mold set-up operator
Prerequisites:
- The trainees should have followed the REP Course "Operating an injection press" or have an equivalent level.
Your A3 trainersGoal of the training:
- To gain a thorough knowledge of the injection process.
- Be able to start a new production and adjust the mold
- Learn how to optimize the process.
Content:
• Introduction
• The rubber
What is rubber?
Rheometry
Flowability
Viscosity
Head losses
• The injection press
Reminders
• Setting the parameters of the injection unit
Temperature
Preparing the compound
Filling the mold
Degassing
• Hands-on training in the workshop
• Overview of the closing unit
Mechanics
Temperature
• Specific machine cycles
Compression - injection
Injection – transfer
• Curing
• The CRBs
• Assessment of a compound
• TurboCure®
• Approach for starting a new mold
• Injection molding faults
Faults on the molded part and possible origin
• Further questions
• Conclusion
The training will be conducted for a minimum of 4 to a maximum of 8 people.The training will take place in two parts. Theoretical training provided in the classroom, and practical training in the workshop with access to adapted machines and equipment. Please note that the training may be postponed in case of health constraints or absences.
Transportation and accommodation costs in Lyon are not covered by REP. The training courses can be adapted to people with disabilities. Please contact us for the appropriate proposal.
